Panel Rígido Málaga2D/3D mesh panel & sheet fencing
Galvanised 3D mesh fence during installation with timber braces beside a young orchard
Guide · slopes

Bases on sloping ground: stepping a mesh fence down a hill

Málaga province is full of slopes, from hillside urbanisations to inland fincas. Rigid panels do not bend, so the way the fence and its base deal with the fall needs planning.

Technical guidesLast reviewed: Bauman Raymond Attila

Why are slopes a challenge for rigid panels?

In short: rigid panels are rectangular and stay level, so on a slope each bay has to be stepped, or the base has to take up the difference.

A rigid mesh panel is a rectangle. Hung level between two posts on sloping ground, it leaves a triangular gap underneath on the downhill side. Over a long run, those gaps add up. There are three main ways of dealing with it: stepping the panels, building a base that follows the ground, or a combination of both.

The right method depends on the gradient, the length of the run, the base type and what the fence has to keep in or out. For dogs or small animals, gaps under the fence are not acceptable; for a simple boundary on a rural plot, small gaps may be fine.

How does stepping work?

In short: each panel is set level, a little lower than the previous one, and the post takes up the change in height; the base steps with it.

Stepping is the classic approach. Each bay is level, and at every post the fence drops by a step. The top of the fence looks like a staircase, which is tidy on steady slopes. Under each panel, the gap is closed by the base, which also steps – either precast plates set at different levels, or a built low wall with a stepped top.

Stepping works with both 3D and 2D panels. The steeper the slope, the bigger each step, and at some point the steps become awkward; then a built wall that follows the ground often looks better.

Posts and concrete base being installed next to a vineyard
Posts and concrete base being installed next to a vineyard

When is a built low wall better than a precast base?

In short: on steeper or irregular slopes, curves and where the fence meets existing walls, because a built wall can be shaped to the ground.

Precast base plates come in a fixed size, which makes them quick on level ground and on gentle, steady slopes. On steeper or irregular ground, a low wall built on site – a murete of blocks or concrete – can follow the terrain, step where needed and absorb small irregularities. Posts are then fixed into or onto the wall.

Our precast base page explains where plates work best. For built walls in more depth, our sister site murosdebloquemalaga.eu covers block walls.

Fitting a precast concrete base plate into a trench next to a paved path
Fitting a precast concrete base plate into a trench next to a paved path

What if the fence line also holds back soil?

In short: a fence base is not a retaining wall; if soil is being held back, a technician must design that structure before the fence is built.

On terraced or cut slopes, the fence line sometimes coincides with a change in ground level, with soil higher on one side. A precast base or a fence low wall is not designed to hold back soil. Over time, the pressure can push it over, taking the fence with it.

If your fence line retains soil, a retaining wall is needed first, designed by a technician – an arquitecto, aparejador or ingeniero. We do not build retaining walls, and we will tell you if we see this situation during the assessment. Once a proper structure exists, the fence can sit on or behind it.

How does water behave along a fence on a slope?

In short: a continuous base can act as a dam; water running down the slope needs a way through or around it.

On sloping plots, rainwater runs downhill, and a closed base across its path can hold it back, soak the ground behind it and undermine footings. During the assessment we look for signs of where water runs, and we plan openings, gaps or drainage points where necessary. This is particularly important on inland plots with heavy autumn rain and on hillside urbanisations where water from several plots meets.

How do we plan a fence on a slope?

In short: measure levels along the whole line, decide the step positions and base type with the owner, then set posts from the top down.

We start by measuring levels along the entire line, not just the ends. That shows where the slope is steady and where it changes. With that information, we propose where each step goes and which base type suits each section, and include the result in the itemised quote. On site, we usually set posts working along the line so each step can be checked against the previous one.

For how posts are fixed at steps, see our posts and clips guide.

Posts and precast base aligned during installation
Posts and precast base aligned during installation
BR
Bauman Raymond Attila
Author and person responsible · Last reviewed:
FAQ

Frequently asked questions

Can a rigid mesh fence follow a slope?

Panels stay rectangular, so the fence is usually stepped. On gentle slopes, a base that follows the ground can reduce the steps.

Will there be gaps under the panels on a slope?

Without a base, yes – triangular gaps on the downhill side. A stepped base or low wall closes them.

Is a precast base suitable for slopes?

On gentle and steady slopes, yes, by stepping the plates. On steep or irregular ground, a built low wall usually works better.

Can the fence base hold back the soil on a terrace?

No. A fence base is not a retaining wall. A technician must design a retaining structure first.

Do you build retaining walls?

No. We will tell you if your line needs one, and you will need a technician to design it.

How big can the steps be?

It depends on the slope and the panel. We decide step positions after measuring levels along the whole line.

What about rainwater running down the slope?

We look at drainage during the assessment and plan openings or drainage points so the base does not act as a dam.

Is a stepped fence good for dogs?

Yes, as long as the base closes the gaps under each step.

Can you combine a low wall and a precast base on the same fence?

Yes. Different sections can use different solutions where the ground changes.

Can you assess a slope from photos?

Photos give a first idea, especially if taken along the line, but levels need to be measured on site before the final quote.

Get a quote

Send photos and the length of your fence line

We build the whole fence – groundwork, base, posts and panels. Send photos and the approximate length for a first assessment and an itemised quote, no commitment.