
Mesh fence on a precast concrete base: a clean edge at ground level
Concrete base plates slot in between the posts and close the gap under the panels. It is the tidy way to finish a mesh fence on lawns, gravel and gardens with dogs.
A mesh fence on a precast base is a rigid mesh panel fence whose posts also hold precast concrete base plates (zócalo prefabricado) along the bottom, forming a continuous concrete edge beneath the panels.
What is a precast base and how does it work?
In short: a precast concrete plate that sits at the bottom of the fence between two posts, held by the posts or by brackets, with the mesh panel above it.
With a precast base, the bottom of the fence is not open. Concrete plates – made in a factory, not cast on site – run along the line between the posts. Depending on the system, the posts have slots or brackets that hold the plates, and the panels are fixed above them.
The plates are partly set into a shallow trench so the bottom is closed and the top is level. That gives you a continuous concrete edge along the whole fence: easier to mow against, harder for animals to dig under and visually neater than panels floating above uneven ground.
It works with both 3D panels and 2D double-wire panels, provided the post system is designed for base plates.

When is a precast base worth adding?
In short: when you want a closed bottom line – for dogs, rabbits, lawns, gravel or simply a tidier finish – on reasonably level ground.
Owners usually add a base for one of these reasons:
- Dogs that dig under fences, or small dogs that slip through gaps
- Lawns and gravel, where a hard edge keeps grass and stones in their place
- Rabbits and other small animals on rural plots
- Appearance: the fence looks finished, with no ragged gap at ground level
A precast base is quickest on level or gently sloping ground. On steeper slopes the plates have to step, and a built low wall can be the better choice. We explain the difference in our guide to bases on sloping ground.

Precast base or built low wall – which one?
In short: precast is faster and uniform on level ground; a built murete adapts better to slopes, curves and existing walls.
A built low wall (murete) is constructed on site from blocks or concrete and can be shaped to the ground: it can step, curve or run alongside an existing wall. It also needs more groundwork. A precast base is made to a fixed size, goes in quickly and gives a very regular line, but it is less forgiving on uneven ground.
We discuss both options at the assessment stage. If you want a rendered, solid wall with mesh or another infill on top, our sister site murosdebloquemalaga.eu covers block walls in depth.

What should be checked before installing a base?
In short: the levels along the line, the boundary position, drainage, and any rules on solid bases in your town or urbanisation.
A base closes the bottom of the fence, which also changes how water moves. On a plot that drains across the boundary, a continuous base can hold water on one side. We look at where water runs before setting the line, and agree how to handle it.
We also check levels along the run: precast plates need a consistent trench, and steps need planning. Finally, some towns and urbanisations have rules on how high a solid base may be or how it must look. Check with the ayuntamiento or your community administrator (check for your address). Our vacant plot rules guide lists what to ask.
How do you maintain a fence with a precast base?
In short: keep soil and debris from piling against the base, check that plates stay seated, and look after the panels as for any mesh fence.
Concrete base plates need very little attention. Keep soil, leaves and gravel from building up on one side, which can push plates out of line over time, and clear drains or gaps where water is meant to pass. If a plate is cracked by a vehicle or a heavy impact, it can usually be replaced individually. The panels above need the same care as any coated mesh fence: occasional rinsing and quick touch-ups of scratches, as explained in our finishes guide.

What affects the cost of a fence with a precast base?
In short: base plates add material and trench work; the slope, the number of steps and the access for heavy plates matter as much as the length.
A precast base is a separate line on our quote: the plates, the trench, the bedding and the fixings. On a level, accessible run that line is predictable. On slopes, each step means extra cutting, levelling and fixings; on sites without vehicle access, carrying heavy plates by hand adds time.
Our fence cost article explains how these factors interact. For general quote advice see presupuestovalla.eu.
How we build it – step by step
- Setting out
We mark the line and check levels, deciding where the base will step if the ground falls.
- Trench and post holes
We dig a shallow trench for the plates and holes for the post footings.
- Post footings
Posts designed for base plates are set in concrete, plumb and at the correct spacing for the plates.
- Placing the base plates
Precast plates are lowered into the trench and seated in the posts or brackets, level along the run.
- Backfilling
The trench is backfilled and compacted on both sides so the plates sit firmly.
- Panels
Mesh panels are fixed above the plates with the clips of the post system.
- Finishing
We check the line, fit caps and touch up any coating damaged during installation.
- Clean-up and handover
We remove spoil and packaging and hand over the finished fence.
When is it the right choice – and when not?
A good fit if…
- Gardens with dogs that dig
- Lawns and gravel areas that need a hard edge
- Rural plots with rabbits or small animals
- Level or gently sloping runs where a uniform line matters
Consider another option if…
- Steep or very irregular slopes, where a built low wall adapts better
- Holding back soil – a base plate is not a retaining wall
- Lines where water must flow freely across the boundary, unless drainage is planned
- Curved boundaries with tight radii
What affects the cost?
We don't publish fixed prices: every fence is quoted line by line using these factors.
- Linear metres
- Panel type and height
- Base plates and their bedding
- Trench excavation
- Slope and number of steps
- Ground conditions
- Access for heavy plates
- Drainage provisions
- Removal of an old fence
- Licence paperwork (owner's responsibility)
Articles and guides

3D mesh panel fence: the folded welded panel, properly installed
The 3D panel is the rigid mesh you see around villas and new housing across the province. We build it on proper footings, with or without a base, from setting out to clean-up.
View details →
2D double-wire mesh panel fence for sites that need a stiffer panel
The 2D panel is flat, heavy-looking and stiff, with each vertical wire held between two horizontal wires. We build it on proper footings for commercial, community and residential boundaries.
View details →
Bases on sloping ground: stepping a mesh fence down a hill
Málaga province is full of slopes, from hillside urbanisations to inland fincas. Rigid panels do not bend, so the way the fence and its base deal with the fall needs planning.
View details →
Common mistakes when choosing a mesh panel fence
Most fence problems are decided before the first hole is dug. These are the choices we see go wrong most often, and how to get them right.
View details →
Vacant plot fencing rules: what to check before fencing a solar
Before fencing a vacant plot, it helps to know what the law expects of owners, which rules are set by the town and what paperwork the ayuntamiento may ask for.
View details →Frequently asked questions
What is a zócalo prefabricado?
It is the Spanish term for a precast concrete base used at the bottom of a fence. The plates sit between the posts under the mesh panels.
Does a precast base stop dogs digging out?
It makes digging under the fence much harder, because there is no gap at the bottom and the plate is partly buried.
Can I use any post with base plates?
No. The posts must be designed to hold base plates, either with slots or with brackets. We check compatibility before ordering.
Can a precast base be used on a slope?
Yes, on gentle slopes, by stepping the plates. On steeper ground a built low wall is often a better solution.
Is the base strong enough to hold soil?
No. A precast base is not a retaining wall. If soil has to be retained, a technician must design a proper structure first.
Will a base cause water to collect?
It can if the plot drains across the boundary. We look at drainage during the assessment and agree a solution.
Can you add a base to my existing mesh fence?
It depends on the posts. If they were not designed for plates, adding a base usually means replacing posts, so it is often close to a new fence.
Is a precast base the same as a murete?
No. A murete is a low wall built on site; a precast base is factory-made plates. Both close the bottom of the fence.
Do the plates come in colours?
Base plates are usually plain concrete. Finish options depend on the supplier at the time of ordering.
Do I need permission for a fence with a base?
That depends on your town and urbanisation. The owner checks with the ayuntamiento; we provide a description of the fence.
Send photos and the length of your fence line
We build the whole fence – groundwork, base, posts and panels. Send photos and the approximate length for a first assessment and an itemised quote, no commitment.